Laim-Care Peroxide - contact lens cleaning solution
Laim-Care
Peroxide is a highly effective hydrogen peroxide-based solution for the care of
both soft and hard RGP contact lenses. Peroxide is generally considered to be
the most effective cleaning agent for lenses. The peroxide cleaning process
always requires a neutralisation phase, using a catalytic disk, during which
peroxide is stabilized and turned into a safe saline solution. It’s extremely
important to carefully follow instructions when using this type
of solution, which makes this product more suitable for experienced
contact lens wearers.
Note:
Never apply
peroxide solution directly into the eyes, as it can cause serious injury.
Never use a flat contact lens case with peroxide solution. Use only
the special case that contains a neutralising disc that is included with the
solution.
Never remove the lenses from the special case before
completion of the neutralisation process (at least 6 hours).
Never
overfill the case with solution. Leaked and non-neutralised solution can
inadvertently come into contact with lenses or your fingers, causing injury.
This is not a multipurpose solution. It is essential to wait for
complete neutralisation (minimum 6 hours) during each contact lens cleaning with
solution to prevent eye damage due to burns. Use following the advice of your
optician.
Laim-Care Peroxide contains 3% hydrogen peroxide, which
must be neutralised using the platinum catalytic disc inside the special
container, included with this product. Make sure to only use the special
container included in the package as this catalytic disk is necessary
for proper peroxide neutralisation.
How to use
Laim-Care Peroxide solution correctly?
Attached to the lid of the
included lens container, you’ll notice a two-sided basket, marked with
R and L -- for your right and left lens
respectively. Fill the base of the container with Laim-Care Peroxide up to the
line. Place your lenses into the lid baskets. Next, close the lid, which will
submerge your lenses and start the neutralisation process. You’ll see bubbles
appear in the container, which indicates that a proper neutralisation reaction
is happening. Now, simply leave the container in an upright position and let
disinfection take place.
The lenses must be left to soak for at
least 6 hours (preferably overnight). Pay attention to not agitate the
container in any way. The solution in the container will become clear and safe
(bubbling will have stopped) when neutralisation is complete. Your lenses will
then be fully cleaned and ready to wear.
If the neutralization time
exceeds 24 hours, repeat the cleaning process.
Laim-Care Peroxide is also
available in following packages:
360 ml
3x 360 ml
4x 360 ml
This solution can only be used
within 2 months after
opening.
Important note
Peroxide cleaning solutions are not
suitable for coloured or crazy contact lenses as they would damage the
lens colours. Peroxide should only be used to clean clear contact lenses.
Comments